Re apply brake at desired bed height.
Happy jack bed lift problems.
Emergency manual operation to manually lower the beds.
From bed lifts and slide outs to tie downs jacks and toolboxes we have a solution for many of your rv needs.
To manually raise the beds.
Bed will slowly drift downward.
Happijac s power lift can accommodate one reversible sofa or a sofa single bunk.
Unplug the motor 2.
So i looked at the instructions and it mentioned a reset by pushing the acc in and out buttons at the same.
I did a search and most post are about the jacks.
Happijac s power bed lift supports up to two queen size beds in an innovative patented double bunk bed configuration.
Bed lift the brake must be released and the motor unplugged.
Happijac bed lift dual support leg installation.
All up press and hold button 6 and all 4 jacks extend to raise the camper.
How can we help you.
All fuses checked out ok.
Generally no more than 4 6 inches.
Remove the motor plug from the pnp control module release the brake lever on the end of the motor if beds are up they will drift downward.
My problem seems to be with the remote.
Position the bed s well out of the upper lower limit switches if possible.
Because the weight of the camper is not the same at all four corners the jacks will not raise and lower at the same speed.
Your happijac experience is important to us.
It just quit on me so i figured i had blown a fuse.
All down press and hold button 5 and all 4 jacks retract to lower the camper.
Beds can be raised out of the way to make room for atvs or other equipment and lowered again when needed.
Be careful not to get camper very far out of level.
If not exercise extreme caution during the following steps to avoid damage to the system.
Happijac bed lift leg support bracket installation.
I m trouble shooting an up raising problem with the beds currently and need to locate the circuit board for the system.
Looking for some help advice regarding my happijac electric bed and it s wiring configuration.
Release the brake 3.
Fj60kai on 03 16 12 11 53am hello folks new member here.
I lifted my camper off the truck and was in the process of lowering it.
