Why or when is a ham station ground necessary.
Ham station sheet metal ground plane.
3 the problem is not rf at all but is a dc power supply ground loop back into the audio system.
Dx engineering radio rf ground plane kits provide an effective method of reducing stray rf pickup by equipment and interconnecting cables.
Copper strap is sold at hardware and roofing stores as flashing.
Ideally you d have a ground plane of around 1 4 wavelength in radius which a pizza sheet can provide on vhf uhf bands but isn t even close on the hf bands.
It is possible to simulate this function by replacing the real earth.
Used under and in back of equipment this 1 16 inch thick pre drilled copper sheet creates an rf reference plane that is typically connected to the existing grounding bus.
4 equipment has a design defect.
A dependent antenna can become effectively useless without one.
Antennas requiring ground planes are called ground plane dependent and having an appropriate ground plane can greatly affect performance.
Then connect the bonding strap or pipe to your ac safety ground rod with a heavy wire.
K7trf aug 19 2016.
Sometimes we set ourselves up for problems without knowing it.
Ham gear usually has a ground terminal just for this purpose.
It is found that for a monopole antenna like a quarter wavelength vertical the ground acts as a plane to reflect the radio waves so that an image of the top half of the antenna is seen in the earth.
5 we have poorly installed connectors or defective cables.
Each time a ground loop is created a small inductive coil is formed the ground wire completes the loop.
As the name indicates the antenna ground plane acts as a simulated ground.
Consider also that most cars have a coat of paint between the mag mount and the sheet metal.
A ground plane is a reflective metal surface that the signal from an antenna bounces off of to better meet the antenna s design goals.
I guess what i m simply not clear on is how a mag mount antenna s ground plane is connected electrically.
That s only 05 wavelengths at 30 mhz which is a tiny ground plane.
Both of these should result in some level of electrical isolation between the antenna feed shield and the sheet metal.
